Surfactant is an essential component for the respiratory system to function properly. This experiment was administrated to help us understand better the role of surfactant in the alveolar system. Surfactant is a detergent-like substance produced by the Type II alveolar cells in the alveoli. Surfactant is produced to make it easier for people to breath by reducing the surface tension of the water molecules that primarily compose the walls of the alveoli; it helps them to not stick together. For this experiment, we will be using milk and food coloring to represent the water (milk) and gas (food coloring) in the respiratory system. Because I know milk is non-polar and food coloring is polar, my hypothesis predicts the two will not mix voluntarily at first, but the soap acting as a surfactant, when added, will help the two liquids mix together.
Materials
(Part on: water surface tension)
1- A penny
2- A dropper
3- Water
4- Paper towels
(Part two: surfactant)
1- Milk
2- 2 different color food coloring
3- Dishwashing soap
4- Cotton swab
The Term Paper on Food Systems and the Environment
The status of food security in any community across the globe can be considered as the major principal outcome of food systems when these systems are defined generically and broadly. Increase in the productivity and efficiency of food systems have shown much success across the globe in improving nutrition and reducing the prevalence of hunger. However the efficiency and productivity of food ...
5- A mall clear dish
6- Timer
7- Paper towel
8- Water
Method
(Part one: water surface tension)
1- Place the penny in a flat area
2- Fill a dropper with water
3- One by one add the drops of water to the top of the penny
4- Measure how many drops fit until the drops break the surface tension of the water.
5- Record results the results table (Part two: surfactant)
6- Placed the dish in a flat steady surface.
7- Then poured the milk making sure the whole bottom of the dish is covered.
8- Add four drops of food coloring to the center of the dish.
9- Let it rest for two minutes and then measure how far the coloring expanded.
10- Record in the result chart
11- Dip the cotton swab in soap
12- Place the end of the cotton swab in the middle of the dish containing the milk and the food coloring.
13- Observe what happens to the food coloring and record the result in the results chart.
14- Throw away the liquids and leave station clean after recording results.
Results
(Part one: water surface tension)
The average drops of water that a penny can hold without spilling the water is 24 drops. In my experiment the results were the following: Trial number
Number of drops
Try one
25
Try two
22
Try three
26
(Part two: surfactant)
When the coloring was placed in the milk at the beginning, it didn’t expand through the milk as quickly as when the soap was added. Without the soap
Expanded 5 ml/min from the center.
With the soap
Expanded at 5cm/ sec from the center.
Conclusion
My hypothesis is accepted. After I applied the drop of soap to the milk, the food coloring spread around. Why? At first, the food coloring just sat on the surface of the milk. That’s because food coloring is less dense than milk, so it floats on the surface. The milk didn’t mix with the food coloring in the beginning because it wasn’t stirred together. The soap reduces the surface tension of the milk by dissolving the fat molecules, which is why whole milk works better. The surface of the milk outside the soap drop has a higher surface tension, so it pulls the surface away from that spot. The food coloring moves with the surface, streaming away from the soap drop. Due to the convection that results from the moving surface, the food coloring may be drawn down into the liquid, only to appear rising again somewhere else. When the soap finally gets evenly mixed into the milk, the action stops. If another drop of soap is added, the process starts all over again. This won’t work in water because water doesn’t contain any fat.
The Essay on Milk, Food Color, And Dish Soap Lab
Purpose/ Objective: The Purpose of this lab is to find out what happens when food coloring placed in different sorts of milks has dish soap (detergent) added to it. Our objective is to determine what the milk and colors will look like after adding the soap. Hypothesis: After preforming the lab one time through, we are able to hypothesize about what could happen when we change different factors ...
