This lab, title Diffusion and Osmosis, was centered around the diffusion across a cellular membrane and how exactly materials move and diffuse in concentrations. Both diffusion and osmosis are forms of movement that are part of passive transport dealing with cell membranes. Diffusion is where the solutes move from an area of high concentration to a low concentration. Water goes through the cell membranes by diffusion. Osmosis is specifically the movement of water through membranes. Since osmosis and diffusion are both part of passive transport, this means that they do not require energy or pumps. There are different environments created due to diffusion. There are hypotonic, hypertonic, and isotonic environments. Hypotonic is when the solution has a lower solute concentration compared to the water potential. The hypertonic solution has a higher solute concentration and lower water potential. In an isotonic solution, there is no net movement and there is an equal concentration of solutes and water. In our lab, we modeled diffusion and osmosis with a hospital scenario.
It is important for an IV solution to have salts in it so the water and solute can be equal to create an isotonic environment. If there wasn’t, there would either be a hypotonic causing the cell to burst, or there would be hypertonic causing the cell to shrink. We created models of living cells by using dialysis tubing. The dialysis tube represented the cell membrane to act as selectively permeable to water and some solutes. We observed different solutes (NaCl, Ovalbumin, Glucose, Sucrose, and Water) in the dialysis tubing.
The Essay on To investigate the effect to the potato cells in the different solute concentration water
Water can move through the different cells due to the difference of water potentials in the cells. If there is a higher solute concentration in the cell than outside the cell, the water will move into the cell. However, if the concentration of inside the cell is lower than the outside, water will not move into the cell. This process is called osmosis. Research question; This investigation will ...
The problem was what environment the solutes would create and whether water would diffuse in or out of the cell. I predicted that all of the tubes will be in a hypotonic environment after the 30 minutes because there is a higher concentration of water outside the cell. The water will diffuse inside the cell, therefore the cell will gain weight. We took the initial weight of each tube with the solute inside, the final weight, and then after took the percent change in weight. The control of the experiment was the model cell where there was water inside and outside the cell. My data proved my hypothesis and led me to conclude that all of the solutions were in a hypotonic environment.
For the second part of the experiment we were to think of an inquiry. The purpose was to identify concentrations of sucrose solutions that we were given. We were to find what solution was closest to being isotonic in order to identify which of them was water. There were 6 different solutions that we observed. There were red, orange, yellow, green, blue, and purple solutions. For my individual inquiry, I used a potato to be placed in the solutions. I found that the potato does not shrink because it has a cell wall which supports and maintains a plant cells structure. I predicted that the potato would remain the same size in the blue solution because it would have an isotonic environment. I thought that if the potato was placed in a hypotonic environment, then the percent change in mass would be greater than if placed in a hypertonic environment.
The Essay on Active Transport Cell Energy Water
1. ) Cellular Transport. Osmosis Osmosis is the diffusion of water molecules across a differentially permeable membrane from a region where water molecules are more concentrated to one where they are less concentrated. The transport of water is simple the cell being selectively permeable will allow water through it until an equilibrium is reached and at that time water will flow both in and out of ...
Materials and Methods
My tested hypothesis was that all of the dialysis tubes (cells) would have a hypotonic environment. If the dialysis tubes were placed in the beaker for 30 minutes, then after the 30 minutes, the water would diffuse in the cell, causing it to gain weight.
For the first procedure, I created model cells with different solutions to determine the rate of diffusion. The weights with the filled cell models can determine rate and direction of diffusion by measuring the percent change of mass and determining the environment after the experiment. A solid control for the procedure is to use water because that is in an isotonic environment, meaning that both concentrations are equal. There were four solutions that were used in the experiment: sucrose, NaCl, glucose, and ovalbumin and the control: water. I took the five dialysis tubings which were acting as cells and filled them with 10 mL of each solution.
We knotted each end but made sure to leave enough space at the top for water to diffuse in the cell. The initial weight was taken and recorded in a data table. The five cells were placed in a beaker filled with water for 30 minutes. After the 30 minutes, the cells were weighed, and the final weight was recorded in the data table, and then the percent change was calculated. The materials used in this procedure were beakers, water, sucrose, glucose, NaCl, ovalbumin, 20 cm-long dialysis tubing and balances.
In the inquiry, I predicted that the blue solution was water and that it would have an isotonic environment, meaning there would be no percent change.I first cut the potatoes into 6 cylinders of the same size by using a cork. I got six beakers and filled each with 20 mL of the different color-coated solutions with different concentrations (orange, red, yellow, green, blue purple).
The initial mass of each potato cylinder was taken before placing in the solution. I placed the potatoes in the appropriate labeled beaker (1-6) of each solution and let them sit there for 30 minutes. After the 30 minutes, I took the final mass of each cylinder and calculated the percent change in mass.The materials that were used in the inquiry were potatoes, corks, pipettes, balances, scalpels, beakers, and the color-coded sucrose solutions.
In this inquiry, the solutions in a hypotonic environment were red, yellow, and blue. Those solutions all had final weights that were greater than initial weights. The orange and green colors both had final weights that were smaller than their initial weights, which means they were in a hypertonic environment. The purple color was in an isotonic environment because the initial and final weights are the same.
The Essay on Beetroot Cell Membranes
Beetroot samples: The same size beetroots will be used throughout the experiment this is to ensure that the impact of the temperature on every sample will stay the same, i.e. if having a bigger beetroot sample less pigments will be released into the test tube at lower temperature, or having a smaller beetroot sample more pigment will be released into the test tube. This error will change the ...
Discussion and Conclusions
In conclusion, my understanding for diffusion and osmosis has been sharpened. I observed the different parts of passive transport: diffusion and osmosis. They both go with the concentration gradient from an area of high to low concentration. My hypothesis for procedure 1, that all of the dialysis tubings would be in a hypotonic environment was correct. This occurred because the tubings were placed in a beaker of water. This means that there was a higher concentration of water than the solute, causing the water to diffuse in the cell after 30 minutes. When water diffuses into the cell, this causes the cell to be enlarged.
Some errors I could have made in the experiments would be failure to pay attention to the timing when the tubes and potatoes were in the solutions, inaccurate measuring when gathering the solutions and the potatoes may have not been exactly the same size. This experiment relates to the AP Biology Big ideas and Science Practices because by observing the cells, I tried to maintain equilibrium or homeostasis by being in an isotonic environment, I also used representations and models to communicate scientific theories when I used the dialysis tubings to form as cells. I properly calculated mathematics by using the percent change formula. I feel I gained more knowledge by questioning and forming my beginning hypothesis for each step.
