Rates of Reaction: Marble Chips and Hydrochloric Acid Rates of Reaction PLANNING AIM To find if changing the concentration of an acid will increase or decrease the rate of the reaction when marble is dissolved in hydrochloric acid. PREDICTION When the concentration of acid increases, more gas will be given off faster. I know this from my trial experiments. METHOD Since I will be working with strong acid, I will wear safety goggles while conducting the experiment.
I will use Marble chips all of a small size. I can use a sieve to make sure they are all roughly similar size- about 7 mm diameter. The amount of acid I have decided on is 10 ml. And so the amount of marble must be in excess – 3 g. I can measure the speed of the reaction by how much gas is given off.
I can measure this in cm 3 in a gas syringe. When the experiment takes place, I will take the reading every 10 second to get a good graph for the results. If the reaction goes very quickly, I will take the readings every five seconds. To be sure I can rely on my results I will repeat he experiment twice or three times if necessary, because there is chance of inaccurate results for many reasons. I learnt from the trial experiments that it is quite hard to start a stopwatch, pour acid and stick a bung into a boiling tube all at the same time, so I will get someone to assist me while doing so. If the experiment goes on for a ridiculous time, I will cut it off.
I don’t think it is necessary to have the experiment go over three minutes, so I will cut it off then. Also, if the amount of gas goes off the scale I will stop it there. It is important to keep the starting temperatures constant for all the reactions as this can affect the results by giving the particles more energy (and making it faster).
The Essay on Nvestigating The Rate Of Reaction Between Marble Chips And Hydrochloric Acid
... of gas that is given off. ยท A Conical Flask – Contains the marble chips, hydrochloric acid and the water that will make the reaction. ... done it so I know what kind of results to expect. Also the experiment I shall I do was done in Chemistry ... so using the evidence I collected from these experiments I know what type of results to anticipate. I shall use a small ...
Analysis of Results. From the experiment, I have found that an increased concentration of acid increases the rate of the reaction. I think tha the best way of displaying these results is by drawing a line graph.
In it, I have used the average of the two sets of results. The pattern I can see is that when the reaction first starts, the reaction is fastest, from then on, the reaction slows. We can see this because the gradient of the curve is steepest at the beginning. The cause of this curve is that at the start of the reaction, there is the most amount of acid molecules that are colliding with the marble. (I can draw this from my initial hypothesis) OBTAINING EVIDENCE TABLE of RESULTS Concentration of Acid. Time 1020304050607080 0.
515202528303234363738 0. 514222833384144474850 12848586779839397100105 1204054647381869299103 240607690100 238557489100 33044708599110 3306290110 47115 4306587110 During the experiment, I kept the starting temperature constant at 23 degrees. I stop watch to time the experiment. I wore safety glasses.
Time is in seconds. Concentration is in morality… I repeated the experiment twice to make sure my results were reliable.
