Every computer has a port to connect a communication line or cable from a peripheral device. Computers have limited number of ports, so multiplexers are used. They combine signals from multiple terminals and put them all on a single communications line. This increases the efficiency of communication and is cost-effective. The communication line is divided into different sections and the data from each terminal is coded and sent and then received, decoded and directed to the correct section from where it came from. There are four commonly used types of multiplexing, the first is (FDM) frequency division multiplexing.
FDM divides the bandwidth of the communication line so that each terminal can transmit data. The individual terminals are separated from guard bands to ensure the signals do not interfere with each other. Multiplexers often have external modems or internal modems built in to convert the data to analog before transmission takes place. The local cable television companies use FDM to send multiple stations over the same line at once. Another method for combining data on a transmission line is time division multiplexing, instead of dividing frequencies to transmit signals, TDM divides the transmission line into time segments. Each terminal is assigned a fixed time slot on a rotation.
The Essay on Power Line Communication
The objective any mining company like TATA STEEL is to reduce the amount of energy used in mining through the increase in employee productivity and safety. Mining operations consist of several tasks. The highest efficiency can only be achieved with full coordination among the persons carrying out these tasks and if the locations of vehicles and people are known by those who coordinate the ...
When the terminals time slot appears it receives the full transmissions capacity for that line. TDM is like packet switching except the time slots are pre-allocated. Instead of using to separate signals TDM uses guard times. If a terminal has no data to transmit at its specific time, the line remains idle. In TDM terminals rarely transmit continuous data which means some sections of the line are almost always idle. In STDM (statistical time division multiplexing) the same concepts apply except if the terminal doesn’t have any information to share it’s time slot will not be created and will move on to the next available terminal, producing less down time.
STDM is driven by data, they also perform more operations than TDM. They provide buffers, and can compress data and report statistics, support digital data, and modem capabilities. The first wavelength division multiplexing system combined two signals and was created 1985, modern systems can handle 160 signals. Telecommunications companies like this technique because they can easily upgrade there lines without having to overhaul the network backbone.
It uses same idea of FDM but with fiber-optic cables. The line assigns each signal a particular wavelength. Early WDM systems were expensive and complicated to run, recent advancements in technology has made them affordable and more user-friendly. There are two types of cables in the market, DWDM is the dense cables run 8 or more active wavelengths per fiber. Systems with less than 8 wavelengths are known as coarse WDM devices. Multiplexers can be intergrade d into networks in many different ways, the number of lines available depends on the type of system being hooked up.
The benefits of a multiplexer are being able to carry multiple signals on a communication line.
