This page is a detail introduction about soybean oil press machine (http://www.oil-processing.com/PRODUCTS/Oil-Pressing-Machine/Soybean-Oil-Pressing-Machine.html) setting up steps. If you are interested in it and you plant to start a soybean oil mill plant, please read on.
1• Cut 1.75-inch metal tubing into two 24.5-inch pieces and one 6.5-inch piece. A carbide saw blade is essential to cut metal; these are available for whatever type of powered or unpowered saw you use to cut the tubing.
• 2
Cut a 5.5-inch piece of flat steel bar and two 8-inch pieces of angle iron. The bar will serve as the top crossbar in your frame while the angle irons will join the frame to a wooden base.
3• Stand all three tubes on their ends, with the long tubes 5.5 inches apart. Place the short tube in between them and use an arc welder to weld the steel crossbar at their top ends, and the angle iron pieces on both sides of their bottom ends. This will make a rectangular metal frame with the short pipe in the middle of one short side.
• 4
File or grind any rough edges from your frame, then paint it. The paint will dampen down any shavings. Once painted, it can be attached to a wooden base by passing screws through the holes in the angle iron piece.
The Research paper on Anti Lice Oil From Guyabano (Annona Muricata L.)
Soursop, also known as guyabano in the Philippines is prominent three times a year; every summer, rainy season and even during Christmas. This kind of fruit is eaten but the tendency of some people is throw away the seeds of it. There are instances that these seeds are used to plant such trees. Some people think that these are useless though it can be used as a treatment for lice since it contains ...
• 5
Make the press canister by welding a circular piece cut from your plate steel onto one end of a wide steel tube. Drill holes through the outside of the canister and file down any rough edges.
• 6
Form the press piston by cutting another circle of plate steel just small enough to fit inside the press canister. On one side of the disk, weld a short length of pipe with a diameter big enough to fit snugly over the end of the short pipe in the press’s frame.
• 7
Chop off the bottom third of a round plastic jug and cut a hole in the center of it big enough for the middle pipe in your frame. This will collect the oil as it drips from the press canister.
• 8
Slide the plastic collection tray over top of the small pipe, then cap the pipe with the piston disk and pile soybeans on top of it. Set the cylinder snugly down onto the pile of soybeans.
• 9
Slide a 3-ton jack between the frame crossbar and the press canister and pump the jack using the attached handle. As the jack extends, it will press the canister down onto the soybeans. The oil squeezed out will drip through the holes in the canister into the collection tray.
Any problem about setting up a soybean oil press machine, please feel free to contact us. Supply Soybean Oil Press Machine all around the world. We offer customers best service and good quality soybean oil press machine and other oil mill machinery.
http://www.oil-processing.com/PRODUCTS/Oil-Pressing-Machine/Soybean-Oil-Pressing-Machine.html
